Wednesday 30 May 2018

Cleaning up the pinching rods

All that was left to do on the pinching rods was to deburr the metal collars, find a way to hold the fixed part of the collars and bevel the ends of the sticks.

Deburring was done with a few passes on a belt sander, I drilled a 3mm hole through one side of each collar until it just started hitting the wood, drove a nail through the hole and across the fixed end of the stick. This doesn't move anymore.

A few seconds of chiseling later, the pinching rods were finished.


I'll make pinch rods using hardwood next, as this one is just a bit too short for the ATC :)

No comments:

Post a Comment